Termination, IR Megger Testing & HIPOT Test  for MV Cable 34.5 KV

This project included the installation of cable ways, lightning, grounding, motors, panel boards, and instrument JBs. It also involved cable laying, cable termination, and the complete electrical and control work for a newly constructed feed mill.

Cutting old cables from the existing duct bank and laying new cables. The work also included cable splicing and termination with PFISTERER plug-in and Raychem heat shrink terminations for MV cables, followed by testing and commissioning.

Cutting old cables from an existing duct bank and laying new cables. The work involved cable splicing and termination using PFISTERER plug-in and Raychem heat shrink terminations, followed by testing and commissioning.

Replacement of old instrument cables, installation and re-routing of new instrument cables, and installation of new RGS conduits with all required fittings and accessories.

Relocated slave PLCs that were dismantled from 44 roller mills and installed them into combined air-conditioned panels with input and output cable extensions.

Installation of grounding rods and networks for MV & LV panels.

Laying, IR & HI-POT testing, and termination of MV cables.

Relocation of instrumentation panels, along with conduiting and cabling works for the upgrade of gas turbine stations.

The laying, termination, testing, and glanding of power and instrument cables.

The supply, installation, and replacement of an HVAC Panel, including motor connection and termination.

Rehabilitation of workers’ locker rooms, bathrooms, and offices.

Removal and laying of a 12-loop cable between two transformers. It also included the installation of Raychem MV power cable indoor end termination kits and post-termination testing with VLF & IR.

Installation of motorised shutter doors at various Marafiq site locations.

Complete supply, installation, testing, and commissioning of electrical & instrumentation equipment. This included cable trays, cable ways, lightning, grounding, earthing, MV cables, transformers, LV & MV panels, motors, actuators, sensors, flow transmitters, PLC controllers, local stations, and slave PLC panels.

Complete installation, testing, and commissioning of electrical & instrumentation equipment. This included cable trays, cable ways, lightning, grounding, earthing, MV cables, transformers, LV & MV panels, motors, actuators, sensors, flow transmitters, PLC controllers, local stations, and slave PLC panels.

Complete supply, installation, testing, and commissioning of MV substation panels, which included the installation, testing, oil filling, and commissioning of a 4.5 MVA transformer.